.shopcontent1 { text-align: center !important; border: 3px solid green !important; margin: 0 auto !important; }

Adjustable Clutch Block and Engine Mounts for 700N - Product Image

Adjustable Clutch Block and Engine Mounts for 700N

The new G-Force clutch block for the 700N allows infinite adjustments for proper meshing between the pinion gear and the main gear. Since the 700N is supplied with a fine teeth main gear, close tolerance meshing is required to prevent stripping under hard collective use. The G-Force clutch block will allow you set up a perfect mesh easily. The clutch block also has extended range to work with other gear ratios.

The G-Force clutch block uses slotted screw holes allowing the clutch block to slide back and forth. The G-Force clutch block is supplied with locking hex nuts that work with the stock 700N shoulder bolts. Fine adjustments can be made without the need for thread locking compound if you need to adjust it.

The other unique feature over other aftermarket clutch blocks are dual pinion bearings that are retained at both ends within the clutch block housing. The G-Force clutch block also allows the use of the stock pinion clutch nut that will prevent endplay of the pinion shaft that rides within the two lower radial bearings. The third bearing top bearing is for the starter shaft support. All three radial bearings are factory installed.

Included with the clutch block kit are specially designed engine mounts which also use locking hex nuts without the need for locking compound each time you adjust it. The G-Force engine mounts will allow you to keep the engine aligned with the clutch block. The engine mounts have the same adjustable range as the clutch block.

-Kit includes Clutch Block and engine mounts
-Factory installed bearings
-Locking hex nuts included
-Complete instructions

NOTE:  Fits only frames that have 60mm inside width.  Check your frame before ordering.

 


SKU Number: GFT7118
Price:   $69.00 
Quantity: